Thread: Homemade intercooler bracket
03-18-2007, 09:58 PM #1
Homemade intercooler bracket
I got my intercooler in from www.siliconeintakes.com on tuesday which was bad ass because i ordered it sunday night. I spent a good chunk of my time this weekend trying several different ways to make an IC bracket and this is what i came up with. It's so rock solid it requires a 3lb sledge hammer to install! Hopefully tuesday i will get MBS to make my plumbing so i can get it all together. I still may add something off the back for a lil more supprt but i think this setup is more than sufficient. I'm just a fan of overkill. Not bad for a drunk huh?
03-18-2007, 10:05 PM #2
- Join Date
- Dec 2006
- Crest Hill, IL
03-18-2007, 10:07 PM #3
made my stock exhaust block off too. Busy night!
03-18-2007, 10:07 PM #4
Planning on rubber banding it? looks good..better than some
03-18-2007, 10:45 PM #5
If i can bolt it down i will on top of some foam that they use under the astroturf in NFL stadiums. If not yeah i'll use the ole rubber band trick. I'm waiting until MBS makes my pulmbing just in case they need to move the IC in any direction.
03-19-2007, 12:07 AM #6
What I did with my bracket (similar) Is I took a tire inner tube and cut a long thin piece to fit on top of the bracket and then I glue it on the top of the bracket were the IC will sit with Dap weldwood contact cement. So the rubber inner tube protects the two. I also used a old battery bunggie to hold the IC to the bracket.
03-19-2007, 12:09 AM #7
03-19-2007, 07:20 AM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By US PERFORMANCE in forum Sea Doo ClassifiedsReplies: 8Last Post: 06-19-2008, 03:15 PM
By cbrich in forum 4-Tec PerformanceReplies: 5Last Post: 03-29-2008, 09:18 AM
By BoostedH23a1 in forum 4-Tec PerformanceReplies: 2Last Post: 06-10-2007, 09:17 AM
By HoopsRXT in forum 4-Tec PerformanceReplies: 1Last Post: 05-05-2007, 11:30 PM
By RXPDAVID in forum 4-Tec PerformanceReplies: 9Last Post: 06-22-2005, 09:31 AM