Thread: Coil wire replacement
12-27-2013, 10:34 PM #1
Coil wire replacement
I am replacing my coil wires, with new 7mm wire. Should I place a small amount of glue on the rubber cap that holds the wire in place?
12-28-2013, 08:48 AM #2
I seal the ends with liquid electrical tape. Keeps the water out and provides a bit of adhesiveness to the assembly. They are glued from the factory, so it wouldn't hurt to put a it of glue in there if you don't want to go the liquid tape route.....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rsmith in forum Yamaha Old School SkisReplies: 4Last Post: 07-26-2011, 08:15 PM
By soejberg in forum Polaris How To & FAQsReplies: 5Last Post: 08-06-2009, 11:15 AM
By 240witSR in forum 2-Stroke PerformanceReplies: 8Last Post: 06-24-2008, 10:05 PM
By VetteTech81 in forum 2-Stroke PerformanceReplies: 8Last Post: 11-01-2007, 11:54 PM
By jcc011185 in forum Polaris PWC PerformanceReplies: 10Last Post: 12-01-2006, 04:51 PM