01-01-2014, 04:00 PM #1
Riva nozzle with interchangeable rings how are u bolting or set screwing the rings?
Been searching and no luck on good pictures. Riva nozzle with interchangeable rings how are you bolting or set screwing the rings so they do not come out? Thanks.
01-02-2014, 11:56 AM #2
We recommend using PTS for the nozzle ring set screws. Tighten evenly (a little on each side) until the nozzle ring is secure without distortion (making it oval shaped). Once you've decided on the nozzle ring size allow the PTS to set up overnight before going "riding".
Our installation instructions can be found online at http://www.rivaracing.com/instructions.asp.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 800AMSOIL4U in forum 4-Tec PerformanceReplies: 11Last Post: 01-02-2014, 03:18 AM
By 305coco in forum Yamaha ClassifiedsReplies: 0Last Post: 06-23-2011, 10:07 PM
By trent_girardrxp in forum Sea Doo ClassifiedsReplies: 3Last Post: 03-22-2011, 09:19 AM
By EGGonz in forum Kawasaki PWC Performance (4-stroke)Replies: 14Last Post: 06-19-2008, 03:33 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 9Last Post: 09-08-2006, 12:43 PM