01-14-2014, 01:10 PM #1
Please help it's driving me mad!!
Ok so I've removed the fuel switch and oil neck on my gp1200r and replaced with a volt meter and taco meter, I wired in them both but the volt meter stays on constantly so I spliced it into the digital clocks as I thought once kill switch was disconnected it would cut power to the volt meter but nope it stays on. So then I thought ill wire it into the kill switch it self and when you power up the ski the needle moves but goes back down as if off.
Please can can someone tell me how to get this working or shall I do constant power and fit a switch???
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By sandonut in forum Polaris Open DiscussionReplies: 38Last Post: 11-01-2013, 10:13 AM
By bustercherry in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-28-2012, 09:49 PM
By Chuck785 in forum Polaris Open DiscussionReplies: 1Last Post: 07-22-2012, 12:18 PM
By rmk82nd in forum 4-Tec PerformanceReplies: 18Last Post: 06-03-2011, 08:31 PM
By CRAZEDRXP in forum Sea Doo Open DiscussionReplies: 11Last Post: 07-05-2005, 09:28 PM