01-16-2014, 03:17 PM #1
New R&D 5 Port Cooling block for 310/300/260/250
R&D 5 Port Cooling Manifold for Ultra 310/300/260/250
The R&D 5 Port Extra Cooling Manifold is a bolt on part that replaces the OEM cooling manifold mounted to the top of the jet pump. For offshore and...
1/2 x 1/2 Through Hull Barb Fitting
Used to bring in a 1/2" hose water source into the hull.
01-20-2014, 04:27 PM #2
Any fitting instructions or diagrams for the water lines
01-20-2014, 05:11 PM #3
Mate its made for those wishing to re route and add extra cooling.
01-20-2014, 05:28 PM #4
i know just seams a bit tight on those elbow fittings on the top, was just wondering the best routing in and out
01-20-2014, 06:33 PM #5
Mate you would position them to suit. They are just pictured that way.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Kawasaki PWC Performance (4-stroke)Replies: 11Last Post: 07-25-2011, 01:18 PM
By Green Hulk in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 04-18-2011, 03:39 PM
By Green Hulk in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 04-18-2011, 03:32 PM
By WFO in forum 4-Tec PerformanceReplies: 10Last Post: 08-28-2008, 11:36 AM
By Hydrotoys in forum Conversion PWC Performance SkisReplies: 79Last Post: 12-09-2006, 10:13 PM