Results 1 to 3 of 3
  1. #1

    how to adjust PV cable?

    About to do the PV clips and couplers tomorrow, but I can't find out how to adjust the PV cable in the service manual. Any tips?

  2. #2
    Waveruiner pauladave's Avatar
    Join Date
    Mar 2007
    Clayton le Woods, North West England,UK.
    Look at the engine block behind the P/V operating wheel (where the cables turn the valves) and you'll see a small hole. Make sure the servo motor for the valves is in the 'closed' position, then put a small screwdriver, or similar, into the hole in the cable wheel, and thru into the hole in the block. This is valves closed position. Now adjust the cables to give a small amount of free play (very little), whilst the holes still line up. Make sure the servo defaults to that position after ignition is turned off, and it's done.

  3. #3
    thanks for the info!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. how to adjust oil pump cable?
    By tgersx in forum Polaris Open Discussion
    Replies: 1
    Last Post: 06-09-2009, 09:04 AM
  2. How to adjust power valve cables
    By tie_one_on in forum Yamaha How To & FAQs
    Replies: 2
    Last Post: 03-25-2009, 05:28 AM
  3. How to adjust steering 1998 GTS?
    By dentonf250 in forum 2-Stroke Performance
    Replies: 4
    Last Post: 03-30-2008, 10:33 PM
  4. how to adjust jetwork valve ?
    By BR549 in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 05-01-2007, 08:24 PM
  5. How to adjust Timing
    By Rompe21 in forum 4-Tec Performance
    Replies: 22
    Last Post: 10-27-2006, 12:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts