01-27-2014, 06:26 PM #1
Pump cone options for the pre-2014 ski using 3 degree nozzle????
I am sure I am not the only person that is going to install a 2014 reduction nozzle on a pre-2014 ski.
So what pump cone do we run?
Lucky 13=would equal 5 degrees.
01-27-2014, 06:37 PM #2
L13 is 3 degrees. I'm going to run the same setup. L13 with 87mm (bored) 3 degree pump nozzle.
01-27-2014, 08:00 PM #3
I thought the L13 cone had a 5 degree angle on the 3 bolt units and a 3 degree angle on the 4 bolt.
01-27-2014, 09:52 PM #4
Nope L13 cones are all 3*
01-28-2014, 07:37 PM #5
Pretty sure it's 3*. When I had the L13 on with a 5* nozzle, it was slightly off center. With the 3* nozzle, it's perfectly centered. Haven't had a chance to run it yet.
01-28-2014, 08:57 PM #6
Yup. Lucky 13 cone is 3 degree. I would run it with that 3 degree nozzle or any nozzle for that matter. I already have the Lucky 13 cone, just need the new 2014 3 degree nozzle! For now I have been using the XLT, but already blew out one of the veins in it cause they are thin.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By nz fulla in forum TigersharkReplies: 0Last Post: 08-28-2012, 07:01 PM
By philip_gpr in forum Conversion Skis ClassifiedsReplies: 7Last Post: 11-12-2010, 11:01 PM
By caliburst in forum 4-Tec PerformanceReplies: 13Last Post: 09-16-2008, 10:26 PM
By skeeterzx225 in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 07-30-2008, 12:47 PM
By carbuff91 in forum 2-Stroke PerformanceReplies: 7Last Post: 11-12-2006, 11:24 AM