Thread: Carrillo Rod Bolt Stretch
03-11-2014, 09:53 PM #1
- Join Date
- Sep 2010
- South Florida
Carrillo Rod Bolt Stretch
Building my 1st 4 tech. New block, CP pistons & Carrillo rods. Stretched the rod bolts (M8 CARR) per Carrillo's instructions.
Cyl#1 In Side .005 / Out Side .006 @ 27 Ft. Lbs
Cyl#2 In Side .0055 / Out Side .005 @ 27 Ft Lbs
Cyl# 3 In Side .0055 / Out Side .006 @ 27 Ft Lbs
Torque value look correct for the stretch? I asked Carrillo about the torque and they said not to worry about the torque value and just stretch the bolts. Appreciate any additional info.
03-11-2014, 10:15 PM #2
Do NOT pay attention to torque. Stretching the bolts is fail proof.
Make sure you check rod bearing clearance.
03-11-2014, 11:59 PM #3
yep, i ignore the torque and do the angle guage and double check with the stretch
03-12-2014, 09:17 AM #4
03-12-2014, 05:22 PM #5
Stretch only, ask me how I know.....BOOM - Take Slow91's advice
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Badvgood in forum 4-Tec PerformanceReplies: 150Last Post: 08-11-2013, 12:00 AM
By dnielsen in forum 4-Tec PerformanceReplies: 1Last Post: 04-29-2013, 04:39 PM
By meeper in forum 4-Tec PerformanceReplies: 4Last Post: 08-13-2009, 05:06 PM
By boostaholic in forum 4-Tec PerformanceReplies: 4Last Post: 04-12-2009, 06:37 AM
By ABBOTT in forum Yamaha How To & FAQsReplies: 7Last Post: 08-03-2006, 12:21 AM