03-31-2014, 01:16 PM #1
Stripped R&D Trim Nozzle Kit? Advice..?
I've got a 2000 gp1200r with a R&D Trim Nozzle Kit. It appears that the middle bolt's socket is stripped. I'm not sure what it's supposed to look like and if perhaps I could put a small nut on the bottom side to hold it in place. Any advice on what I should do?
Please see attached images.
03-31-2014, 01:22 PM #2
there appears to be enough to install a helicoil in that boss the bolt goes through
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By skizzott in forum Yamaha PWC Performance (4-stroke)Replies: 1Last Post: 02-25-2014, 11:29 AM
By maildude in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-02-2011, 02:11 AM
By maildude in forum Sea Doo ClassifiedsReplies: 0Last Post: 06-02-2011, 12:17 AM
By vxrpete8 in forum Yamaha ClassifiedsReplies: 14Last Post: 01-08-2011, 02:03 PM
By inchadeboca in forum Kawasaki PWC Performance (4-stroke)Replies: 1Last Post: 09-03-2008, 04:38 PM