Thread: Jet Pump build
04-19-2014, 09:51 AM #1
Jet Pump build
2010 RXT-X260; Jet pump cracked.
I don't see anything on the "how to" to assemble a Jet Pump.I've ordered all the parts on the OEM drawing. Is there anything important that I should or shouldn't do?
05-07-2014, 03:45 PM #2
Make sure you get grease infront of bearing behind the seal and pack the rear as full as you can so there is as little air as posible. Air can compress letting water in and grease wont. I prefur some of the seadoo tools . dont press the bearing in pushing on the shaft press on the out er race and when seating the bearing on the shaft press only on the inner race of the bearing. dont forget the snap rings.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jcameronrxp in forum 4-Tec PerformanceReplies: 0Last Post: 07-12-2012, 05:13 PM
By nick072010 in forum Polaris ProjectsReplies: 7Last Post: 06-04-2012, 12:42 AM
By Pale Rider in forum Sea Doo Open DiscussionReplies: 1Last Post: 06-24-2006, 04:34 PM
By CarFanatic in forum 4-Tec PerformanceReplies: 7Last Post: 06-05-2006, 06:19 PM
By somefun in forum 4-Tec PerformanceReplies: 5Last Post: 06-03-2006, 02:36 PM