Results 1 to 2 of 2
  1. #1

    jt1200 stx12f coupling

    trying to remove the coupler from the crank. is this thread clockwise or counter clockwise? Having trouble getting it to turn. Fashioned a holder tool for the timing plate. im afraid to bend it. Is their loctite on the shaft and will heat loosen it assuming im turning it the right way. Suggestions appreciated. BTW im using a chain wrench on the coupler and a breaker bar. Motors out and would like to get it back in this weekend. Any pointers would be appreciated. TIA

  2. #2
    Take the time to smile sirbreaksalot's Avatar
    Join Date
    Jun 2007
    U need the coupler remover ,,,, heat ,,,,, and an impact gun
    And the timing rotor tool only make you buy new rotors

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. couple 150+ mph passes on my old R6.....
    By VFX_Artist in forum Sea Doo Open Discussion
    Replies: 13
    Last Post: 12-09-2005, 01:53 PM
  2. Couple pump ?'s
    By Vman in forum 4-Tec Performance
    Replies: 7
    Last Post: 12-05-2005, 04:23 PM
  3. I ran into a couple forum friends on the water today!
    By Green Hulk in forum Sea Doo Open Discussion
    Replies: 15
    Last Post: 09-19-2005, 03:18 PM
  4. Advise for a couple of new skis
    By jack in forum Sea Doo Open Discussion
    Replies: 4
    Last Post: 06-10-2005, 02:10 PM
  5. Hey guys a couple of small tips about our boats...good info
    By two2curupt in forum 4-Tec Performance
    Replies: 4
    Last Post: 05-21-2005, 04:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts