Thread: Wiseco PNs
06-09-2014, 06:44 AM #1
Wiseco doesn't list all their pistons on their site. Anyone have their oversized and overbore part numbers for reference here?
06-09-2014, 06:59 AM #2
they may be dealer only pistons
that is most of the manufactures are doing nowdays
06-09-2014, 07:01 AM #3
great. I'll probably just send the whole thing to Chris this winter and let him deal with it. Engine only has 50hrs on it but I want to keep spinning 9K +. The pull up there is amazing.
06-09-2014, 07:08 AM #4
for what it worth IMO the stock pistons are fine for those rpms
but the tune needs to be good
there is actually less chance for knock up there
06-09-2014, 07:22 AM #5
I'd think so too since there are turbo guys on 18psi-20psi running all stock internals. I know there's difference in efficiency but psi is psi. in the cylinder. I'll figure out my issue tomorrow, hopefully. It still pulled hard as all hell.
06-09-2014, 07:27 AM #6
06-09-2014, 07:29 AM #7
I was going to do everything local and Pletcher is not a Carrillo dealer. If I send it out I'll just get the 9.5 CPs and Molnar rods. Keep it light.
06-09-2014, 08:08 AM #8
now what i have is 10.1 compression if you go with wiseco make sure you do from 31/2 to 4 on piston clearance no less..
06-09-2014, 08:10 AM #9
06-09-2014, 08:12 AM #10
Get the Carrillo rods......they come as a matched set weight wise!!! The crank WILL need rebalancing.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By utahnewbie in forum Polaris Open DiscussionReplies: 1Last Post: 05-26-2007, 10:53 AM
By PolarisNut in forum Polaris PWC PerformanceReplies: 5Last Post: 04-04-2007, 01:55 PM
By bluesonic in forum 2-Stroke PerformanceReplies: 9Last Post: 03-07-2007, 07:05 PM
By oldmanraider in forum Yamaha Old School SkisReplies: 8Last Post: 12-23-2006, 09:38 PM
By falcondrummer in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 02-17-2006, 10:03 PM