Results 1 to 3 of 3
  1. #1

    Join Date
    May 2007
    Location
    Suffolk, VA
    Posts
    79
    +1
    1

    sealing the case

    Does the sealant go only on the outer sides of the case? Or does it need a thin layer on all the flat surfaces?


  2. #2
    Bob 1tommygunner1927's Avatar
    Join Date
    Apr 2007
    Location
    Houston, Texas
    Posts
    6,380
    +1
    982
    Outside and the crank/balancer areas at the front flat areas.

  3. #3
    dsteinmann's Avatar
    Join Date
    Apr 2012
    Location
    St Louis
    Posts
    278
    +1
    8
    All the mating surfaces, YOu can roll it on

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do I seal the upper and lower cases?
    By Mark S in forum 4-Tec Performance
    Replies: 4
    Last Post: 03-18-2009, 11:53 AM
  2. 900 ZXI/Sealing The Cases
    By superdave in forum Kawasaki How To & FAQs
    Replies: 6
    Last Post: 01-08-2009, 06:54 PM
  3. Cylinders stuck to the case?
    By MPower in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 06-11-2007, 07:38 PM
  4. Seal the transom ?
    By mrbtd in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 04-04-2007, 02:34 PM
  5. To seal the pump or not ?
    By mtrager in forum Yamaha Open Discussion
    Replies: 3
    Last Post: 03-23-2007, 02:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •