Thread: Piston Wash Opinions
03-30-2007, 07:30 PM #1
Piston Wash Opinions
I just pulled the head off my '04 1300 so I can put on the head I got back from Jim. I wanted to post a few pics of the pistons, just to see if someone sees any problems with the piston wash. I didn't touch the tops of the pistons - this is how they came out. I also have the RIVA EFI controller.
03-30-2007, 07:46 PM #2
03-30-2007, 08:24 PM #3
Yup......shes runnin a lil lean.
03-30-2007, 08:44 PM #4
They do not look too bad, but I would fatten it up just a little.
03-30-2007, 09:02 PM #5
Thanks guys. I'll be kicking her up a notch or two on the EFI controller.
Here is the settings I have been running with just the d-plate.
03-31-2007, 07:38 AM #6
03-31-2007, 10:05 AM #7
Richen up just a little on top.
03-31-2007, 10:11 AM #8
Are those potientiometers scales from 1-9 ?
am I reading the notches correctly ?
asking to learn....
Last edited by RX951; 03-31-2007 at 10:15 AM.
03-31-2007, 10:18 AM #9
03-31-2007, 10:21 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kevski in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 10-01-2007, 03:42 PM
By TheDome in forum Yamaha PWC Performance (2-stroke)Replies: 31Last Post: 08-24-2007, 10:04 PM
By mtrager in forum Yamaha Open DiscussionReplies: 5Last Post: 05-11-2006, 07:37 PM
By mtrager in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 05-04-2006, 02:53 PM
By Hydrotoys in forum Yamaha Open DiscussionReplies: 7Last Post: 01-13-2006, 06:38 PM