06-14-2014, 08:53 PM #1
What Aftermarket Grips to Fit Pre 2012 VTS Assembly
I am planning to retrofit to the pre 2012 VTS handle/assembly, where the entire grips turns - as opposed to the pita setup they are offering now. Also now is a good time to upgrade my grips.
Not sure if the full length VTS handle is the same diameter as the the other grip/bar side (so I can just order ODI's from the store). Or if I need to find/order a different diameter to run VTS side? Are both sides still 120mm, or will I have to order a 120mm set & a 130mm set? Would not mind being able to run some bar extenders too.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 1fastxpp in forum 2-Stroke PerformanceReplies: 11Last Post: 07-16-2010, 04:08 PM
By 2&4strokepolaristech in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 09-24-2009, 04:40 PM
By repoman in forum Kawasaki Open DiscussionReplies: 1Last Post: 09-12-2008, 01:51 PM
By FL03GTX in forum 4-Tec PerformanceReplies: 2Last Post: 06-03-2008, 09:30 AM
By Stainless in forum 4-Tec PerformanceReplies: 2Last Post: 09-16-2007, 08:43 PM