06-19-2014, 05:08 PM #1
Seadoo Rxp 215 2007 mod hull cleaning and oil dripping from shaft from engine
Hi i was wondering if anybody here have a good tip for me for washing the hull on my rxp?
The hull is full of old oil. looks like i have some leaking from the main shaft on the motor, dripping slowly.
have any body heard about omega that u use in the oil ?
for lubricate up the o/sim Rings ?
how do i get the water out of the hull after i am done with the wash.
do i need to purchase a little electric pump to pump it out.
or can i flush out the 2 rear plugs in the back.
06-20-2014, 08:52 AM #2
Purple Power and a power washer will have the inside of the hull looking brand new, On the 07 RXP just tilt it up and use the drain plugs. anything left you can soak up with a carwash sponge a few times.
You probably need a new bearing and Bellow 420832648
06-20-2014, 02:35 PM #3
Omega 917 Seal Saver
ok. vill do that in the winter time, it is not lekaing to much, just dripping.
but have anybody of you guys tried out Omega 917 Seal saver on you seadoo ?
i have heard allot of good about that seal saver.
i can use this or trye it in the mean time.
06-20-2014, 02:40 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ktmracer153 in forum 4-Tec PerformanceReplies: 22Last Post: 06-16-2012, 02:47 PM
By ktmracer153 in forum 4-Tec PerformanceReplies: 3Last Post: 05-28-2012, 11:18 AM
By slow07rxp in forum Sea Doo 4Tec SkisReplies: 3Last Post: 08-07-2010, 10:11 AM
By kbaker13 in forum Sea Doo 4Tec SkisReplies: 7Last Post: 07-24-2010, 08:41 AM
By RudyJ in forum Sea Doo 4Tec SkisReplies: 1Last Post: 08-30-2009, 10:17 AM