Results 1 to 4 of 4
  1. #1

    Join Date
    Nov 2009
    Location
    Toronto
    Posts
    84
    +1
    2

    HOW TO: Is this oil pump / parts recoverable

    Hi guys,

    I am preparing on making a list of parts I need to get. Some I will try to use ebay and other I will buy new depending on the price. I would like to change as little parts as needed as this been done about 22 hours ago by a shop already charging me over 6k.

    For the Oil Separator, I understand this is the front oil pump and it`s very important for not loosing oil pressure. This was replaced before my SC drive gear broke.

    Out of these 4 parts in the pictures, can I reuse any of them or I need a few or all new ones ?. I have seen a complete oil separator pump on line but not sure how it looks inside it might look just like mine or worst ...

    Thanks a lot for helping out.
    Click image for larger version. 

Name:	frontoilpump.jpg 
Views:	62 
Size:	40.8 KB 
ID:	333883Click image for larger version. 

Name:	frontoilpump2.jpg 
Views:	57 
Size:	40.0 KB 
ID:	333884Click image for larger version. 

Name:	frontoilpump3.JPG 
Views:	64 
Size:	39.6 KB 
ID:	333885Click image for larger version. 

Name:	frontoilpump4.jpg 
Views:	59 
Size:	53.7 KB 
ID:	333886Click image for larger version. 

Name:	frontoilpump5.jpg 
Views:	59 
Size:	45.0 KB 
ID:	333887


  2. #2

    Join Date
    Nov 2009
    Location
    Toronto
    Posts
    84
    +1
    2
    anyone thinks I can use some of those parts or buy all new ones ?

  3. #3
    Mine looked just like that I orderd all new pumps. It's worth the money to replace it while u have the engine out and apart then later down the road after a potential failure.

  4. #4

    Join Date
    Nov 2009
    Location
    Toronto
    Posts
    84
    +1
    2
    did you change the PTO housing as well, how much did it cost you to do it ?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to remove the Extension, Pump part #5131196????
    By heebeha in forum Polaris How To & FAQs
    Replies: 5
    Last Post: 06-03-2012, 11:54 PM
  2. How much is this going to cost me ?
    By pratzert in forum Sea Doo Open Discussion
    Replies: 14
    Last Post: 06-13-2010, 06:18 AM
  3. Is there a way to test my oil pump.
    By 951ccshoe04 in forum Yamaha How To & FAQs
    Replies: 3
    Last Post: 01-10-2010, 10:39 PM
  4. Is there not a how to for an oil change?
    By Muddinking in forum Polaris How To & FAQs
    Replies: 4
    Last Post: 07-06-2009, 07:03 PM
  5. How bad is this going to hurt me?
    By racerx585 in forum Yamaha PWC Performance (2-stroke)
    Replies: 14
    Last Post: 05-20-2009, 06:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •