Thread: Ultra 250x 08 Ride plate.
06-28-2014, 02:43 AM #1
Ultra 250x 08 Ride plate.
Do i need to use any type of sealant when fitting my R+D ride plate and intake grate. I use my ski for racing.
Thanks in advance,
06-28-2014, 04:20 AM #2
You don't have to, I never did because I would swap setups for different race conditions so much.
But you can use silicon to seal the gap around the intake grate and ride plate to the hull. Some say it helps, but I didn't see a difference other than being more difficult to swap setups
06-29-2014, 03:24 AM #3
Sticky 5mm foam tape works a treat.....it also allows for swapping out without resealing silicone
06-30-2014, 03:38 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
FS - Parts Kawasaki ULTRA 250X Ride Plate (Stock)By Socaloffshore in forum Kawasaki ClassifiedsReplies: 0Last Post: 04-30-2013, 11:28 PM
By Skips313 in forum Kawasaki PWC Performance (4-stroke)Replies: 42Last Post: 11-06-2009, 11:50 PM
By ercBOOSTED in forum Kawasaki ClassifiedsReplies: 2Last Post: 09-28-2009, 04:53 PM
By Mack77 in forum Kawasaki Open DiscussionReplies: 1Last Post: 10-02-2008, 10:33 PM
By blue 250x bandit in forum Kawasaki ClassifiedsReplies: 0Last Post: 05-23-2008, 10:32 PM