Thread: Intake grate install question?
04-01-2007, 04:42 PM #1
Intake grate install question?
Anyone tried using 3M 4200 to help keep it in. I have read a few post where there have been some problems and it has got me a little worried. Just want to make sure I only do this once. I would assume heating up the bolts would help them come out too? And some use red and some use blue loctite. Heck, some even use red on the front and blue on the back. Thanks for any advice.
04-01-2007, 09:29 PM #2
Just use red loc tite on all the bolts and some Permatex Right Stuff on the mounting surface on the front of the grate to help seal around the bolt hole.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Gateway Tone in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 06-28-2012, 10:28 PM
By boosted-delslow in forum 4-Tec PerformanceReplies: 11Last Post: 06-04-2011, 10:42 PM
By K-Dubb in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 04-26-2011, 11:12 PM
By griffin55 in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 05-29-2010, 03:41 PM
By WebmasterRXP in forum 4-Tec PerformanceReplies: 3Last Post: 07-08-2008, 06:39 PM