Results 1 to 2 of 2
  1. #1

    951 big end rod bearing size and suggestions?


    I am rebuilding a crank to a 951 DI and I want to install high quality bearings onto the shaft and rods but I cannot locate the size of the big end bearing on the rod as well as the thrush washers. Does anyone have a size/code that I can use to give to my bearing suppliers? I am looking to install SFK bearings, any suggestions?

  2. #2
    Hi All,

    does les anyone have any suggestions on the above? Want to get this done soon but not getting a response.

    cheers and thanks for looking

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Rod bearing size
    By tealgreen2000 in forum Yamaha PWC Performance (4-stroke)
    Replies: 1
    Last Post: 03-12-2016, 10:54 AM
  2. anyone have problems installing new small end rod bearings??
    By psycho rxp in forum 4-Tec Performance
    Replies: 4
    Last Post: 06-16-2010, 04:39 PM
  3. vx110 crank and rod bearings
    By seaya in forum Yamaha PWC Performance (4-stroke)
    Replies: 3
    Last Post: 06-20-2009, 08:38 AM
  4. jetworks valve size and one other question
    By bow tie klr in forum Yamaha PWC Performance (2-stroke)
    Replies: 12
    Last Post: 06-13-2006, 10:43 PM
  5. Fuel lines-what size and mfgr?
    By cfgp927 in forum Yamaha PWC Performance (2-stroke)
    Replies: 13
    Last Post: 01-22-2006, 04:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts