Thread: xp oil block-off install
04-01-2007, 10:27 PM #1
xp oil block-off install
When I install the block-off plate I just took off the pump, took the o-ring off and put it on the block-off plate and put the plate on to the motor. Did I have to pull out that part inside that turns the oil pump or is what I did O.K?
04-02-2007, 05:04 AM #2
The only inside piece that turns that pump, if it's like Yamaha would be the flywheel.
04-02-2007, 05:37 AM #3
Yes, you should take out the plastic drive shaft.
04-02-2007, 07:46 AM #4
if I go to pull out that plastic driveshaft, what is behind it?
04-02-2007, 08:45 PM #5
It just fits into the crank end. Nothing needs to be plugged inside. Just plug the Mag cover and cap the oil lines at the manifold.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By bfal in forum Yamaha How To & FAQsReplies: 1Last Post: 05-12-2008, 02:53 AM
By DTV in forum Yamaha Old School SkisReplies: 6Last Post: 05-04-2008, 06:41 PM
By gerhand44 in forum Polaris How To & FAQsReplies: 6Last Post: 04-26-2007, 08:54 AM
By joshxp in forum Polaris Open DiscussionReplies: 4Last Post: 03-30-2007, 11:28 AM
By gerhand44 in forum Polaris How To & FAQsReplies: 3Last Post: 09-25-2006, 08:45 PM