Thread: gp200r not getting off idle
07-06-2014, 02:18 PM #1
- Join Date
- Aug 2011
gp200r not getting off idle
I have a 2001 gp1200r. I was having a problem with the ski loading up the idle and fine on top. I just deleted the oil pump and went pre mix. I have a new issue, when i start the ski the low fuel warning light and alarm goes off. The fuel is full. This all started after sitting all winter. After I deleted the oil pump I put it in the water and I can't get it to go over idle without stalling. I still havnt seen if the deleting the oil pump worked because she stalls to easy. I have to feather the throttle to keep it running. I believe the fuel sending unit is bad thats why the alarm is going off. Can a bad sender make the ski run bad? Or is this something else. I have always found if somethings broke after you messed with it then you usually did something. Any ideas????
07-08-2014, 10:30 AM #2
Have the carbs ever been rebuilt ? If not, that's a good thing to do. Use Mikuni parts only. I'd stay off it until you're able to rebuild. I'd check all your connections to the fuel sending / sensor for corrosion etc. If they're good, you may need a new unit.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By flyboy in forum Yamaha PWC Performance (2-stroke)Replies: 22Last Post: 07-03-2007, 09:40 PM
By NateGP1300R in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 05-30-2007, 12:11 AM
By reisenback in forum Kawasaki PWC Performance (4-stroke)Replies: 31Last Post: 01-25-2007, 09:34 PM
By RXPBeast in forum Sea Doo Open DiscussionReplies: 11Last Post: 06-11-2006, 09:32 PM
By CRS in forum 4-Tec PerformanceReplies: 14Last Post: 03-02-2006, 08:25 AM