Results 1 to 3 of 3
  1. #1
    C-Phase's Avatar
    Join Date
    Nov 2013
    Location
    South Jersey
    Posts
    88
    +1
    1

    Exclamation Ok I'm stumped and need your alls help ASAP !!

    1996 1100 triple wave venture.
    Bought it a week or so ago. It sat for a few year. Gas was never drain and stale. Pumped it all out, swabbed the inside of the tank and got it CLEAN. Changed the in line filter. Started it on the trailer ran good RPMs went right up.
    Water tested it and under load she wouldn't take the gas.
    Ordered carb kits, re built them and installed them last night.
    Started it ran fine.

    This brings me to this morning. All excited and was going to take it out, tried to start it at home first it turned over about twice and stopped. Put the battery charger on it for a while same thing. Get NEW battery same thing spins about once or twice and stops. Pulled the spark plugs and the back cylinder is full of gas. Spun it over and a guysher of gas and oil shoot out. Went to hit it again and all I hear is the starter solenoid click???? Wait a while and she spins again and I keep spinning it until it clears out the cylinder.
    Put the plug back in and she spins over like a raped ape but not starting. Flooded maybe???

    Try it again and same thing with the solenoid. No spin just click.

    Kind of at a loss here and need some advice.
    Ran fine out of the water before the carb rebuild. Ran last night after the rebuild but I did start it as soon as it was buttoned up and back together. But now it sat over night and the #3 cylinders was flooded.
    How did that cylinder get so flooded. Fuel cut off switch was turned off. Also someone replaced the choke with a primer.

    Plus this starter thing? Is there some type of limiter on it to prevent over heating/cranking?

    thanks guys
    newbie the the PWC world.


  2. #2
    C-Phase's Avatar
    Join Date
    Nov 2013
    Location
    South Jersey
    Posts
    88
    +1
    1
    Just walked back out and it spun over for about 5 seconds. I stopped, hit it again and click & no spin.............. Grrrr

  3. #3
    C-Phase's Avatar
    Join Date
    Nov 2013
    Location
    South Jersey
    Posts
    88
    +1
    1
    Please delete. Posted same thing in old school forum. Sorry

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ok I'm stumped and need your alls help ASAP !!!
    By C-Phase in forum Yamaha Old School Skis
    Replies: 5
    Last Post: 07-07-2014, 07:13 PM
  2. stx 15f need help with jet pump removal (new to forum and need your help)
    By Geno in forum Kawasaki PWC Performance (4-stroke)
    Replies: 3
    Last Post: 02-24-2012, 09:53 PM
  3. 96 780 success and need your input
    By awilson in forum Polaris How To & FAQs
    Replies: 2
    Last Post: 08-09-2011, 10:22 PM
  4. Replies: 1
    Last Post: 05-16-2011, 08:31 AM
  5. Replies: 15
    Last Post: 08-11-2007, 08:26 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •