07-07-2014, 07:19 PM #1
GPRXP Seadoo Pump Adapter Dimensions Needed
I am currently building a gpr conversion and working on the pump section. Is there any dimensions for the seadoo pump adapter anywhere? I've searched the forum up and down and no luck. If anyone could throw a sketch or a print up that would be stellar.
07-07-2014, 07:47 PM #2
they are all different ... mine is 80mm thick , some are 75mm and some are 20mm . the 20mm thick one uses the Yamaha 2" spacer . hope this helps
07-07-2014, 08:00 PM #3
07-07-2014, 09:08 PM #4
Thanks for the info, every bit helps. I'm currently drawing a Solidworks model and just need a few more dimensions.
Perhaps the bolt hole pattern dimensions, OD of the boss adjacent to the ID and the diameter of the ID.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ercBOOSTED in forum Yamaha PWC Performance (4-stroke)Replies: 2Last Post: 09-06-2010, 09:29 AM
By JFizzleJR in forum Conversion Skis ClassifiedsReplies: 0Last Post: 08-03-2010, 12:43 PM
By islandboy in forum Conversion Skis ClassifiedsReplies: 6Last Post: 05-18-2010, 09:57 PM
By deansta in forum Conversion FAQ and TipsReplies: 0Last Post: 03-11-2010, 05:46 AM
By hydrojunkie in forum Conversion PWC Performance SkisReplies: 15Last Post: 01-19-2010, 12:54 AM