Thread: GP1300R Ride Plate Questions
07-08-2014, 03:50 PM #1
- Join Date
- Jul 2013
- Canyon Texas
GP1300R Ride Plate Questions
Ok, so my tunnel has been fixed, and I am now stage 2 + ish...
The riva ride plate that I have does not fit on my 1300R... so im using the stock plate, and im getting a lot of proposing...
How does the R&D plate fit up to the 1300R? or should I buck up and order a "Shredmaster" ???
2003 GP1300R, Riva Exhaust, dplate, single bar intake grate, power filter, pump reinforcement, 13/19 Solas, Jetworks Valve, Metal Trim tabs, pump shoe stuff't, EFI controller (stock settings). Sponsons have been stepped (down in the rear), 5 degree exit nozzle.
Also, im a little disappointed in the Riva Exhaust... I thought it would be louder, replacing all of that crap with at straight pipe... but it sounds the same (just a little bit of a deep growl)... anything I can do to make it LOUD and obnoxious? different waterbox maybe?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jetskibill9999 in forum 4-Tec PerformanceReplies: 1Last Post: 05-14-2007, 08:06 PM
By porksword in forum Yamaha PWC Performance (2-stroke)Replies: 38Last Post: 08-25-2006, 01:59 PM
By Lvnspeed in forum 4-Tec PerformanceReplies: 6Last Post: 08-04-2006, 07:16 PM
By Alex13 in forum 4-Tec PerformanceReplies: 3Last Post: 07-27-2006, 10:07 PM
By Alex13 in forum Sea Doo Open DiscussionReplies: 3Last Post: 07-27-2006, 10:07 PM