Thread: Boost Gauge Install
07-12-2014, 09:48 PM #1
07-12-2014, 10:26 PM #2
Either run the R&D multiport adapter or tap the intake manifold on the front or rear zip tie boss (depening upon if your intercooler interferes and where you have your bov line)
07-12-2014, 10:32 PM #3
according to the instructions, the barb for the vacuum line on the sensor MUST be facing down. so we mounted it on the underside lip of the divider wall to the left of the electrical box(red circle in pic).
07-13-2014, 07:34 AM #4
Don't even touch the pressure sensor. Just drill and tap manifold simple and easy.
07-13-2014, 08:40 AM #5
07-14-2014, 07:15 AM #6
Has anyone used one of these to run a boost and afr gauge?
seems a lot less mucking around than tapping the manifold or would I get more accurate readings that way?
also will that part work on svho?
07-18-2014, 06:38 PM #7
07-19-2014, 07:28 AM #8
- Join Date
- Jun 2010
- Milwaukee WI
Nice looking install!!!!
07-19-2014, 10:13 AM #9
07-05-2015, 03:24 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ad_gpr in forum 4-Tec PerformanceReplies: 36Last Post: 05-20-2009, 03:41 PM
By RXP Blur in forum 4-Tec PerformanceReplies: 14Last Post: 12-08-2007, 02:32 AM
By JFizzleJR in forum 4-Tec PerformanceReplies: 12Last Post: 06-18-2007, 08:52 AM
By Shibby1485 in forum Sea Doo Open DiscussionReplies: 25Last Post: 07-22-2006, 11:40 AM
By Snoman in forum 4-Tec PerformanceReplies: 2Last Post: 05-14-2006, 06:58 PM