07-16-2014, 09:50 AM #1
MSX 140 ?? Digital Wrench?? Ficht EMM
Where is there a port on the Ficht EMM that if I had a copy of Digital Wrench it would plug into?
I have two mid 90's Polaris Indy EFI sleds that I use a PC version of Select Monitor on. Had to make my own cable.
Is there something like this for the Ficht EMM that someone would not have to purchase?
Cannot get the full view of the PC screen but the link is below.
07-16-2014, 11:48 AM #2
- Join Date
- Jul 2007
- near Toronto, Canada
There is a four pin WeatherPack loop back connector in the wire harness near the EMM. Four wires on one side and a single White/Red wire on the other side.
The Polaris diagnostic cable connects to the four wire connection. It uses standard RS-232 serial cable signals (send, receive, ground) with a proprietary data protocol.
Polaris offered two diagnostic software programs. The now outdated DOS based PODIAG and the newer Digital Wrench Windows based software.
07-16-2014, 02:24 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By kaotic1 in forum Polaris Open DiscussionReplies: 25Last Post: 10-26-2013, 11:49 AM
By fixer in forum Polaris Open DiscussionReplies: 1Last Post: 06-28-2011, 10:40 AM
By ncdoo in forum Polaris Open DiscussionReplies: 2Last Post: 07-02-2010, 04:38 AM
By jeto in forum Polaris ClassifiedsReplies: 2Last Post: 08-19-2008, 09:21 AM
By f150vtx in forum Polaris PWC PerformanceReplies: 13Last Post: 08-16-2007, 04:43 PM