Thread: 2010 RXTX pump removal
07-19-2014, 12:21 AM #1
2010 RXTX pump removal
Having a few problems tying to remove the bolts that hold my pump to the ride plate. Someone has put some good locktite on there. Is there any tricks that would help me with this?? I heard heating the bolt helps but im a bit cautious about doing this when they are into the alloy ride plate.
07-19-2014, 05:26 AM #2
07-19-2014, 06:40 AM #3
Heat gun and quality tools.
07-19-2014, 08:11 AM #4
07-19-2014, 10:51 AM #5
07-19-2014, 11:52 AM #6
07-19-2014, 05:23 PM #7
I modified this 'old' bolt with a grinder.
Just to clean the threads from the loctite.
Haha it came not out like that !!
You can use a tapping tool as well but they are tapered at the tip so more change damaging the soft aluminium when you start....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By DinoMite in forum 4-Tec PerformanceReplies: 9Last Post: 01-05-2014, 07:32 PM
By pete71 in forum 4-Tec PerformanceReplies: 10Last Post: 04-09-2013, 09:07 AM
By ronnoc2 in forum Sea Doo Open DiscussionReplies: 3Last Post: 07-07-2011, 03:51 PM
By Throttlemire in forum 4-Tec PerformanceReplies: 54Last Post: 01-11-2011, 01:32 PM
By Glade Rider in forum 4-Tec PerformanceReplies: 3Last Post: 09-24-2010, 02:21 PM