Results 1 to 2 of 2
  1. #1

    Join Date
    Aug 2010

    Waveblaster with Protec Pipe Jetting?

    Anyone help with jetting specs.
    Ive just rekitted the carbs.
    It dies in the high rpms

    38mm dual carbies (stock)
    125 main
    75 pilot
    Long silver springs

    Protec Mach1 pipe
    TDR Waterbox
    Everything else is stock

  2. #2
    Hope you have figure this issue out. I just rebuilt a WB2 crank up with carbs and it falls on its face after 5 seconds of WOT. I have done some research and others have had the same problem. Cleaning the Fuel Selector Valve is a good place to start. Remove, clean and verify its operation. Then check the fuel tank vent and make sure the check valve is working properly and allows air into the fuel tank. Im about to troubleshoot my issue and there are 3 items to check right off, fuel selector valve, fuel tank vent and the fuel pickups in the tank.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Waverunner 500 with Protec Pipe?
    By capone27 in forum Yamaha Old School Skis
    Replies: 2
    Last Post: 07-10-2014, 09:56 PM
  2. water routing on a blaster with a vxr protec pipe
    By 87r in forum Yamaha How To & FAQs
    Replies: 0
    Last Post: 04-23-2013, 05:48 PM
  3. GPR 800 cyl with triple pipes INFO!!!
    By fraratti in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 11-13-2006, 07:15 PM
  4. Riva cooler with aluminum pipes
    By nickdog in forum 4-Tec Performance
    Replies: 22
    Last Post: 09-15-2006, 02:19 PM
  5. 1200-65u Triple Pipe Jetting Help
    By wb1205 in forum Yamaha PWC Performance (2-stroke)
    Replies: 8
    Last Post: 02-06-2006, 10:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts