Thread: Ultra 300 cooler rack
07-21-2014, 06:18 PM #1
07-21-2014, 07:56 PM #2
07-21-2014, 08:00 PM #3
looks like you use some PVC pipe with a few 45* elbows and guess you tie it or strap it one or both rear handle grips?
07-21-2014, 09:24 PM #4
07-22-2014, 08:50 AM #5
- Join Date
- May 2014
Nice. All else fails just buy the plattinum products one with the rod holders. Thing is built like a tank and has been great for me thus far (very shorty trial but I don't fore see any issues.)
07-22-2014, 11:04 AM #6
Get some plumbing isulation and wrap the PVC where it contacts the ski. If you left enough room can be used where cooler slides in to help snug it up and protect it as well. This is what I did with my gas jug holder.
I just used eletrical tape to secure the insulation. Zip ties would/could work as well but the sharp edges when you trim them suckers....
07-22-2014, 01:25 PM #7
07-22-2014, 01:47 PM #8
07-22-2014, 09:10 PM #9
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By TexasMason in forum Polaris ClassifiedsReplies: 39Last Post: 04-17-2016, 05:38 PM
By TexasMason in forum Sea Doo ClassifiedsReplies: 56Last Post: 08-23-2011, 01:51 PM
By TexasMason in forum Yamaha ClassifiedsReplies: 12Last Post: 07-29-2008, 08:10 PM
By TexasMason in forum Kawasaki ClassifiedsReplies: 5Last Post: 07-09-2008, 05:36 PM
By nonvtecdaturbo in forum Polaris Open DiscussionReplies: 21Last Post: 12-21-2006, 12:20 AM