07-25-2014, 10:03 AM #1
4tec Intake & Exhaust Valve Height
Looking for the intake and exhaust valve height. Mesaured from the spring seat (without the the valve seal) to the tip of the valve.
I mesaured it a while ago and lost the paper.. didn't notice it was gone till the guides were out and the head got a valve job.
I need these mesaurements so i can figure out how much to tip the valves.
07-29-2014, 03:18 PM #2
07-29-2014, 07:17 PM #3
You have hydraulic lifters, no need to cut the valves
07-29-2014, 09:06 PM #4
07-30-2014, 07:38 AM #5
Been there done that , need to have them measured stock before changing valves ...
yes they are hydraulic but too high can still break the rocker ...
07-30-2014, 08:14 AM #6
07-30-2014, 08:34 AM #7
If your seats have been cut ...then ur valve heights will vary ...
07-30-2014, 10:06 AM #8
This is not my first rodeo guys... as I said I had everything down but lost the paper.
All I need is the messearmrnt
07-30-2014, 12:17 PM #9
not what your looking for but im looking
Last edited by big john; 07-30-2014 at 12:35 PM.
07-30-2014, 12:48 PM #10
Well shit John you're close! I owe you a beer just for that LOL
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By DR2006RXP in forum 4-Tec PerformanceReplies: 6Last Post: 12-01-2013, 08:28 PM
By steach in forum Sea Doo ClassifiedsReplies: 4Last Post: 04-28-2013, 08:56 PM
By Roger H in forum Sea Doo ClassifiedsReplies: 3Last Post: 02-04-2013, 08:20 PM
FS - Parts 2012 rxpx intake and exhaust valvesBy tweeker in forum Sea Doo ClassifiedsReplies: 0Last Post: 03-16-2012, 08:32 AM
By rxpdz in forum Sea Doo ClassifiedsReplies: 3Last Post: 12-01-2010, 06:25 PM