Thread: Genesis PERC
07-25-2014, 01:56 PM #1
Anyone swapped a Gen i rev into a carb Gen?
Thx to a sweet deal from Marineking, I have a PERC from a Gen i.
I'm going to try putting the whole assebley with cable into my carbd Gen.
07-27-2014, 06:23 AM #2
I successfully installed the rev in my Gen. It works perfect. Now to figure out why the rev needle on the MFD(I) goes 3/4 of the way to rev then jumps back up.
07-29-2014, 01:03 PM #3
- Join Date
- Jul 2007
- near Toronto, Canada
My guess is that the switch for the reverse signal is dirty or there is a loose connection somewhere.
There are two separate signals for Reverse on a PERC electric reverse. The Reverse mode signal and the reverse position signal. MFI needle position will always be forward unless the Reverse Mode signal is active. Only when Reverse Mode signal is active will the needle be allowed to move.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rsracin05 in forum Polaris Open DiscussionReplies: 35Last Post: 06-27-2014, 04:01 PM
By VegasRatt in forum Polaris Open DiscussionReplies: 1Last Post: 11-06-2006, 08:59 AM
By VegasRatt in forum Polaris PWC PerformanceReplies: 6Last Post: 10-05-2006, 09:16 PM
By VegasRatt in forum Polaris Open DiscussionReplies: 8Last Post: 09-21-2006, 11:55 PM
By VegasRatt in forum Polaris Open DiscussionReplies: 6Last Post: 09-12-2006, 09:26 AM