Thread: 310 need tips for customer
07-30-2014, 06:10 PM #1
310 need tips for customer
We have a customer who just got her 310.
The dealer reflashed the ski with our stage 1 software.
The dash now shows 8150, but speed is low 70-71 mph
Then the dealer installed r&D intake grate, this made the rpm go down to 8000 and speed was still same 70-71 mph.
what is best mods to get the speed up?
07-30-2014, 06:19 PM #2
Are they getting full boost 15-17 on gauge,will start from there...
07-30-2014, 06:21 PM #3
07-30-2014, 06:37 PM #4
Yep you should be at 73-74 mph minimum....
No ride plate intake grate combo gonna give you 3 mph,stock prop I assume you have by your RPMs should give you that little extra top speed too..
Somethings not right,just wondering is trim at 1-2 or 3 down,I would spin same rpms 1-2 down as neutral but be at your 70-71 instead of my best 73-74...
07-30-2014, 10:25 PM #5
My 310 se runs an easy 74 -high 75 depending on conditions & fuel loads
stock ski other than a K-speed reflash .
its only getting better as I now add mods
07-31-2014, 12:30 AM #6
07-31-2014, 01:35 AM #7
07-31-2014, 03:02 AM #8
For your info, I spin ~ 7750 @ 70MPH... full trim up
Something is not right.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rxp546 in forum Sea Doo Open DiscussionReplies: 15Last Post: 02-14-2013, 02:50 PM
By ktyamaha36 in forum Sea Doo Open DiscussionReplies: 3Last Post: 06-22-2010, 11:15 PM
By stevorxp007 in forum Sea Doo Open DiscussionReplies: 2Last Post: 10-27-2009, 06:43 AM
By bonanzaman in forum Kawasaki PWC Performance (2-stroke)Replies: 0Last Post: 05-24-2009, 11:16 PM
By Coonass in forum Sea Doo Open DiscussionReplies: 16Last Post: 12-14-2006, 06:30 PM