Results 1 to 4 of 4
  1. #1
    Treemn's Avatar
    Join Date
    Jun 2007
    Location
    Coral Springs FL
    Posts
    3,325
    +1
    641

    How to Remove Stainless Wear Ring ????

    I looked for this in search but did not see it. what does it take to remove stainless wear ring. Treid freezer do you have to dremel it out ? I have a spare pump going to use it for now any help would be apperciated. Can post pictures later it has burrs like frmn cavatation on the edges of the blades.

    Thanks
    scott e


  2. #2
    Moderator Snoman's Avatar
    Join Date
    Apr 2006
    Location
    South Chicagoland
    Posts
    14,688
    +1
    846
    The last one i removed i froze over night,then once out i took t butain torch and heated the outside of the pump up and used a long punch and hammer and knocked it out...its not a 20 second job,thats for sure..

  3. #3
    Nothin' better than Doo'in it! BigDaddyRXP's Avatar
    Join Date
    Aug 2007
    Location
    Tampa Bay, FL
    Posts
    9,202
    +1
    673
    Freeze the pump with the prop off overnight, then take a 4x4 around 2-3 foot long and drill a hole in one end of it to clear the pump shaft. When you pull the pump out of the freezer, set it on the 4x4 and heat the shit out of the exterior with a map gas torch.... once good and hot hold the pump with one hand and the 4x4 with the other and slam the 4x4 - pump on a concrete floor. I've never not been able to get one out doing it this way.

  4. #4
    Treemn's Avatar
    Join Date
    Jun 2007
    Location
    Coral Springs FL
    Posts
    3,325
    +1
    641
    Thanks pump in freezer and I made the 4 x 4 item will see if i can get it out tomorrow evening Thanks Again

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How To: Remove Spark pump to change wear ring and impeller
    By Green Hulk in forum Sea Doo Spark
    Replies: 13
    Last Post: 06-10-2016, 07:10 AM
  2. How-to: Pump Pulling - Wear Ring Swap - Prop Swapping
    By Green Hulk in forum Sea Doo How To & FAQs
    Replies: 160
    Last Post: 07-28-2014, 07:29 PM
  3. Replies: 4
    Last Post: 07-24-2013, 07:30 PM
  4. how to remove the wear ring??
    By ryan*9 in forum 2-Stroke Performance
    Replies: 10
    Last Post: 08-18-2007, 09:31 AM
  5. How do you get stainless wear ring out?
    By Pale Rider in forum 4-Tec Performance
    Replies: 9
    Last Post: 04-29-2007, 03:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •