08-06-2014, 01:48 PM #1
Leftover part after 4tec rebuild. Please help me figure out where it goes...
08-06-2014, 01:53 PM #2
Looks like the chain tensioner or crank locking hole plug washer
08-06-2014, 02:02 PM #3
- Join Date
- May 2013
08-06-2014, 02:21 PM #4
Only areas i can think of with a rubber washers are the valve cover and throttle body bolts.
08-06-2014, 02:34 PM #5
Definitely rubber, you can fold it in half. I checked the chain tensioner, no place for this guy there, and the diagram only features the big aluminum seal washer. The valve cover had those bolts with thick black rubber grommets under the head, and they were all accounted for. Not sure about throttle body, but doubt it as I took that off long before I messed with the rebuild. I'll check the diagram for that again just in case.
08-06-2014, 03:16 PM #6
if it is rubber then it won't be the two places I mentioned for sure. It looked like metal to me, I didn't see where you mention the rubber.
08-06-2014, 03:35 PM #7
This engine will be sitting on the shelf for some time, so if anyone identifies this, please let me know before I put it in the boat.
08-06-2014, 03:39 PM #8
I can't think of any place that would go
Everything used on these engines that looks like that is metal.
08-07-2014, 12:13 AM #9
08-07-2014, 06:26 AM #10
Looks like the beer needs to be replaced. Nobody got time for that bottled Mexican sweat
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ronsrx700 in forum Yamaha How To & FAQsReplies: 0Last Post: 04-14-2014, 02:18 PM
By newwbiesl750 in forum Polaris Open DiscussionReplies: 10Last Post: 06-25-2011, 08:44 AM
By sebas54 in forum Polaris Open DiscussionReplies: 3Last Post: 05-13-2010, 11:17 AM
By vinny347 in forum Polaris Open DiscussionReplies: 84Last Post: 02-19-2010, 09:14 PM
By John in forum Yamaha PWC Performance (2-stroke)Replies: 19Last Post: 01-12-2006, 08:21 AM