Results 1 to 4 of 4
  1. #1
    xdrian's Avatar
    Join Date
    Nov 2008
    Location
    Brisbane Australia
    Posts
    898
    +1
    225

    Looking for any advice on Sea-Doo iS top deck 2009 is re installation help

    Looking for any advice on Sea-Doo iS top deck 2009 is re installation help

    Looking for any wiring diagrams would help.

    Trying to get the hydraulics down to normal level maybe manual reset how to.


  2. #2
    Tiny's Avatar
    Join Date
    Sep 2006
    Location
    The Atl
    Posts
    3,561
    +1
    578
    You need to lift the front legs up with a small wooden block. Then set the upper deck back on. Attach the deck to the front first, loosely. then attach one or 2 of the bolts to the suspension base. Once all bolts are in lower the back down and install the 6 bolts in the back...Hopefully you marked the hull where the rear braces are supposed to sit otherwise alignment will be a bitch!!!!

  3. #3
    xdrian's Avatar
    Join Date
    Nov 2008
    Location
    Brisbane Australia
    Posts
    898
    +1
    225
    Thanks Tiny always read your advice in the spark section thanks for all your input

    done all the above the problem is that the hydraulics is in the high point is there any way to run the motor manually to pull down the center mount 6 bolts is just to high any advice would be great Thanks

  4. #4
    Tiny's Avatar
    Join Date
    Sep 2006
    Location
    The Atl
    Posts
    3,561
    +1
    578
    You would have to plug the wire harness in and lower it with the key pads on the handle bars...It is tough to put those in because they dont line up well and because they are so high up there... I will tell you to use a shiv or pick of some kind to help you line up the upper deck to the plate or you wont get it. Get one of the wholes to line up and loosly install 1 bolt and the rest will be easier to install....

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for some advice on where to get parts, questions inside
    By TurboTony in forum Polaris Open Discussion
    Replies: 1
    Last Post: 09-03-2014, 01:04 AM
  2. FS garmin 76 csx like new!! for glove box on sea-doo
    By phumb in forum Sea Doo Classifieds
    Replies: 2
    Last Post: 01-10-2012, 01:14 PM
  3. FS - Parts garmin 76 csx like new!! for glove box on sea-doo
    By phumb in forum Sea Doo 4Tec Skis
    Replies: 3
    Last Post: 01-08-2012, 08:04 AM
  4. Looking for buyer advice on 96 hx
    By 96sltx1050 in forum 2-Stroke Performance
    Replies: 9
    Last Post: 09-07-2009, 08:49 PM
  5. Sea-Doo is possibly re-designing there wear rings!!
    By NeverEndn in forum 4-Tec Performance
    Replies: 10
    Last Post: 08-09-2006, 04:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •