09-13-2014, 02:04 PM #1
Chunk missing from Supercharger Wheel
This 2007 RXP had SC rebuilt w/ updated washers (by Jerry) in 2009; thought the SC was golden until I started reading the forums again and learning the SC bearings are prone to failure if not rebuilt according to recommended schedule.
Took the SC off today and saw a small chip missing from the wheel. Was very alarmed until I found this thread ...
Want to double check that the small chunk missing from this wheel is normal and OK, and was done for wheel balancing.
Thanks in advance for replies
09-13-2014, 02:28 PM #2
09-13-2014, 02:28 PM #3
- Join Date
- May 2012
yep, typical balance mark
09-13-2014, 07:07 PM #4
09-13-2014, 07:56 PM #5
09-13-2014, 08:24 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By razorback88 in forum 4-Tec PerformanceReplies: 10Last Post: 12-18-2007, 11:33 PM
By dochere195 in forum 4-Tec PerformanceReplies: 5Last Post: 07-17-2007, 10:36 PM
By codymouse54321 in forum 4-Tec PerformanceReplies: 18Last Post: 07-05-2007, 08:16 PM
By green05rxt in forum 4-Tec PerformanceReplies: 10Last Post: 06-06-2007, 03:11 PM
By Jeff C in forum Sea Doo Open DiscussionReplies: 13Last Post: 10-25-2006, 09:40 PM