Thread: Next Project
04-09-2007, 01:12 PM #1
Installed cer bearings & GH washers &VT impeller ,slip test @ 75,installed in motor..on to next project
Purchased a SC "basket case" from classifieds.Shaft,gear,bearings,impeller is toast.However,the bearing reliefs & back half of housing is good.The front is scared/scored.
Can this be repaired?
I would like to make this one The "SUPER DUPER CHARGER"
04-09-2007, 02:47 PM #2
That's not too bad. I would just clean it up with some emery cloth and call it a day.
04-09-2007, 03:26 PM #3
I'm gonna do some research on the forum tonight after work & come up with a determination on how far I'm going with the SC
ps STG 3..unsure of SC cofiguration/options though
04-09-2007, 03:29 PM #4
I say go the stage 3 route, then you don't have to worry about that front housing
04-10-2007, 06:40 AM #5
- Join Date
- Jan 2006
- Puerto Rico
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By thester71 in forum Polaris Open DiscussionReplies: 3Last Post: 08-28-2011, 09:18 PM
By thester71 in forum Polaris Open DiscussionReplies: 11Last Post: 04-08-2011, 10:43 PM
By daltonruss in forum Polaris ProjectsReplies: 10Last Post: 06-02-2010, 02:31 PM
By sbogi in forum Yamaha Open DiscussionReplies: 0Last Post: 03-13-2006, 10:27 PM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 7Last Post: 02-13-2006, 11:38 PM