Thread: Gunwale Replacement - 07 GP1300R
10-21-2014, 01:29 PM #1
Gunwale Replacement - 07 GP1300R
I am planning on replacing the rubrail (gunwale) on my GP1300R. I need the right side only but I am not sure on how to complete the project? Are their rivets or screws and do they need to be replaced? Has anyone does this before? I appreciate any help. Below is a list of parts.
10-21-2014, 04:21 PM #2
Hi Ryan, yes & yes . There are both some rivets and a lot of screws. Remember the front bumper must come off 1st then slight the rub rail forward to the bow & remove from ski. Then you get access to the rivets & screws. Not to hard but time consuming. Good Luck
10-22-2014, 11:09 AM #3
10-22-2014, 11:40 AM #4
just because this is about the rub rails has anyone turfed theirs like the stand up guys do?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jaywaite in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 07-26-2010, 11:11 PM
By MattM in forum Yamaha How To & FAQsReplies: 1Last Post: 05-29-2010, 09:44 AM
By tat2biz in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 03-27-2010, 02:41 AM
By toolman11K in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 06-14-2009, 02:20 PM
By bode1 in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 10-08-2008, 09:24 PM