11-02-2014, 12:25 PM #1
Gtx intake grate, is this sitting correct? Please help.
Hi guys, I was just about to fit my new solas intake grate in my 2004 Seadoo GTX limited.
Now ow when i cleaned the bottom of the ski ready to fit I put the grate up against the hull and noticed there was a step ( grate not sitting flush against ride plate) is this normal or should it sit flush? I can't remember if the factory one was the same or not as I took it off over a week ago and give it to a friend to weld it back up as it broke.
Ive attached pictures below. Thanks in advance
Last edited by Fosta; 11-02-2014 at 03:34 PM.
11-02-2014, 12:48 PM #2
11-02-2014, 12:51 PM #3
11-02-2014, 12:58 PM #4
11-02-2014, 02:32 PM #5
11-02-2014, 02:37 PM #6
Any one else got any ideas on what to do with this grate to get it to fit?
Surly i cant be the only one that's came across this problem, do I need to get it Milled down or just grind the top face ( side that touches the ride plate ) to get it to sit flush. If you have come across this problem what did you do?
Huge thanks guys
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 15Last Post: 06-29-2010, 08:07 PM
By Quad411 in forum Sea Doo ClassifiedsReplies: 3Last Post: 09-20-2009, 07:48 PM
By patrick webb in forum Yamaha Open DiscussionReplies: 10Last Post: 07-22-2009, 09:53 AM
By 05Limited in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-30-2009, 11:33 PM
By RXP6 in forum Sea Doo ClassifiedsReplies: 2Last Post: 04-28-2009, 10:04 AM