11-22-2014, 07:41 PM #1
P060D error has anybody had one of these if what was the out come ??
PCODE MODULE DESCRIPTION CAUSE ACTION
P060D ECM TAS (Throttle Accelerator
sensor) synchronization error
Check system circuits B-E1,
B-K1, B-K3, B-A3, B-B3, B-J3
Check for 0 volt on sensor
connector pin B & E.
Check for 5 volts on sensor
connector pin A & D. The 5 volt
supply is shared between the
TAS signal 1, TOPS and MAPS.
Verify all three sensor if one
is pulling too much current.
Check for 0.5 to 3 volts
on sensor connector pin
Fand 0.25 to 1.5 on C
Refer to the service manual
11-22-2014, 07:57 PM #2
Check your TOPS like it says...How does the ski run??
11-22-2014, 10:04 PM #3
It beeps at push start button check engine light comes up.
Does start ok runs ok was running ok while on the water lucky as was in big surf.
I have looked in the manual for tops see no mention of it can you point me to where it is Thanks
With the Vtech maptunner read codes got PC6C8 P0223 P0122 P0222 and P060D
I managed to clear all codes except the P060D is hard on I have reset the both ECU connectors and checked the throttle sensor cable is in nice and tight as two weeks ago it fell out and I found easy fix.
As I have only one week warranty left going to call dealer tomorrow before it runs out
Last edited by xdrian; 11-23-2014 at 03:42 AM.
11-23-2014, 09:00 AM #4
I would have to look at a wiring diagram for the Spark and wont be able to do that til tomorrow at the shop...
11-24-2014, 10:08 AM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By SD1976 in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 05-18-2014, 03:11 AM
By spannerspencer in forum MSX/MatrixReplies: 2Last Post: 04-27-2011, 08:46 AM
By MPower in forum 4-Tec PerformanceReplies: 19Last Post: 02-22-2009, 01:21 PM
By holdnon72 in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-22-2007, 09:10 PM
By mxl16 in forum 4-Tec PerformanceReplies: 22Last Post: 07-13-2005, 09:33 PM