Thread: Custom ALU intake SHO
12-10-2014, 03:54 PM #1
Custom ALU intake SHO
A custom Intake from HydroFool GPR/SHO.
Will also fit to FZR/FX/SVHO with custom piping!
Injektors are some cheap spitfire 750cmf (FREE with the intake,recomended to buy new one and throw this to garbage)
Custom CNC fuel rail with an8 fittment (included with the intake matched set)
Trottle body (70mm) with tps.
Map sensor/air temp bosch 3 bar.
And a air sensor stock SHO.(i'll keep that and putting a plug instead there)
6- 8mm ports with vacum.(if you not need all plug then plug them 1/8 treed npt)
Powder coated sea-grey.
i did drive with vipec on this skii.
high recommended a seriously engine tuner to install this intake its not a easy match with piping setup and its very little space to install it.
and if somebody want to drive with the stock SHO throttle body i can make a cnc adapter to fit but that will take 1-2 weeks extra and then i want a deposit befor i start to make it.
can take race parts in trade to SHO.
Last edited by thomaswester; 03-06-2015 at 01:32 PM.
12-10-2014, 03:56 PM #2
03-06-2015, 01:33 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 305coco in forum Yamaha ClassifiedsReplies: 1Last Post: 04-07-2011, 11:37 AM
By SeaLion in forum Polaris How To & FAQsReplies: 9Last Post: 08-25-2006, 08:01 PM
By FireFox in forum 4-Tec PerformanceReplies: 8Last Post: 06-03-2006, 07:32 PM
By Shibby1485 in forum 4-Tec PerformanceReplies: 29Last Post: 10-22-2005, 01:24 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 17Last Post: 07-08-2005, 07:40 PM