12-20-2014, 07:19 AM #1
RXTX 2010 pump and pump support Question
hello everyone , sorry for my english , i'm french ...
I have few questions about rxtx pump 2010 et pump support
Is it possible upgrade pump support with pump support of 2014
"271001775 PUMP SUPPORT" ?
If it's possible i can use hold pump 2004 - 2009 ?
And install old shaft ( rxt 2004 - 2009 ) and drive shadft with C-clip ?
12-21-2014, 06:15 AM #2
You can use the later model pump support but you will need to drill holes into the hull to make it work as the 2010's have pumps bolted to the ride plate and not the hull. i believe you will need the 2012 on pump to work with that pump support.
Im trying to figure out how to make my pump line up properly with my through hull and engine...least with the old set up you can shim the pump shoe to get the pump aligned 100%...
12-23-2014, 05:12 AM #3
TY pete , i just can uses the new pump 2012 + on the support pump 2012 ??? the old pump isn't compatible ( 2004 - 2009 ) on the support pump 2012 ???
No problem drill hull !
12-23-2014, 06:01 AM #4
12-23-2014, 08:54 AM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cliff0413 in forum Conversion Skis ClassifiedsReplies: 12Last Post: 06-20-2013, 04:15 PM
By Bompys0716 in forum Polaris Open DiscussionReplies: 1Last Post: 05-25-2010, 11:06 PM
By TexGpr in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 05-18-2010, 08:20 PM
By TheXrider in forum Sea Doo ClassifiedsReplies: 4Last Post: 05-22-2009, 07:27 PM
By Snoman in forum 4-Tec PerformanceReplies: 6Last Post: 04-13-2006, 06:37 AM