Thread: Bench Power EMM ??
01-19-2015, 03:55 PM #1
Bench Power EMM ??
I'm trying to bench power an EMM so I can get it's history and injector specs from PODIAG. I'm hitting a wall and unable to communicate. My cable/software works fine on the ski.
I have a spare harness, and both ground terminals are connected directly to a battery, and I have the small red wire going to the positive battery post. I also have a wire coming off the positive battery to the white/red wire. This *should* be all I need right?
I also have a capacitor, and LR503 installed on this harness. I'm about to the point of cutting up the harness. I have 2 spare EMM / Injector sets sitting here that I'd like to test.
01-19-2015, 05:32 PM #2
- Join Date
- Jun 2010
- Milwaukee WI
Im guessing that the EMM would get its actual ground through the stator harness,.
01-19-2015, 06:13 PM #3
Nope. I figured it out. Needed to have the start stop switch connected and have the lanyard installed.
Works great now.
01-19-2015, 07:46 PM #4
- Join Date
- Jul 2007
- near Toronto, Canada
Ficht EMM is grounded through a bunch of black wire harness wires connected to the huge 40-pin connector and to the 8-pin connector. Some of those Black wires end up connected to the engine block via ring terminals.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tshank123 in forum Kawasaki How To & FAQsReplies: 15Last Post: 10-21-2013, 05:12 PM
By K447 in forum Polaris Tech Tips and InfoReplies: 10Last Post: 10-09-2013, 10:19 PM
By leejax01 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 01-21-2012, 02:56 PM
By joeg in forum 4-Tec PerformanceReplies: 10Last Post: 05-22-2005, 03:24 PM
By Jrsrxp in forum 4-Tec PerformanceReplies: 1Last Post: 04-30-2005, 10:25 AM