Results 1 to 3 of 3
  1. #1
    thetolleyman's Avatar
    Join Date
    Jul 2010
    Location
    Williamsburg, VA
    Posts
    562
    +1
    2

    Swapping out 587 for a 717, can i use the same electronics?

    I've got a 95 SPi with a bad motor, and a couple 717 engines in garage. I was hoping to just swap. Can I keep all the 587 electronics? I've got larger carbs and the right exhaust and such, just not sure about the electrics.


  2. #2
    If i knew,...I wouldn't ask sea-one's Avatar
    Join Date
    Aug 2009
    Location
    Dallas/Waxahachie
    Posts
    2,340
    +1
    109
    not compatible, the 657cc will work though

  3. #3
    Only the 94's with the 5 wire plug won't work. If it's the 4 wire it will plug and play. The 587 rev limiter is lower but you can run the 720 impeller to keep the revs down. Be sure to use the 720 pipe, carbs, and water routing.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Can i use the riva athena on the new 2016 RXT X 300???
    By Emol:TX in forum 4-Tec Performance
    Replies: 11
    Last Post: 03-24-2016, 06:37 AM
  2. Can I use the impeller off my 2008 rxp-x 255 on a 2004 rxp 215 ski
    By travis ingram in forum 4-Tec Performance
    Replies: 3
    Last Post: 02-17-2015, 01:02 PM
  3. Replies: 2
    Last Post: 02-10-2011, 04:03 AM
  4. Swapped out GTX shaft for RXT shaft
    By Red Devil in forum 4-Tec Performance
    Replies: 15
    Last Post: 10-26-2005, 12:40 PM
  5. Can you use the blue hose connectors on the Power pipe also?
    By Therock in forum 4-Tec Performance
    Replies: 4
    Last Post: 06-06-2005, 02:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •