Thread: toggle switch for MFD
04-12-2007, 07:59 PM #1
toggle switch for MFD
Has anyone installed a toggle switch to there MFD? I was thinking about putting a toggle switch on the gound wire going to the MFD and leaving the switch in the hull. That way I can turn it off, and keep from burning out the LCD's. I would like some input. Will this erease the memory on the hours of the engine?
04-12-2007, 08:21 PM #2
It shouldn't erase the hours, you will have to re-set the clock each time BUT no biggie.
04-12-2007, 08:29 PM #3
maybe the voltage spike would do more harm each time you switch it on???
04-12-2007, 08:31 PM #4
04-12-2007, 08:45 PM #5
04-12-2007, 10:10 PM #6
I have a toggle for the pink wire (limp mode). It just disables the fuel gauge on the MFD when it goes into limp mode and then no more limp mode. I have it mounted on my dash with a rubber waterproof cover. I'm sure you can do the same for the whole gauge if you like?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By OutlawGPR in forum Kawasaki ClassifiedsReplies: 6Last Post: 11-06-2008, 08:13 PM
By ruinplay in forum Kawasaki ClassifiedsReplies: 0Last Post: 06-04-2008, 08:46 AM
By Js_440_78 in forum Kawasaki How To & FAQsReplies: 1Last Post: 03-16-2008, 09:57 AM
By mrbtd in forum Yamaha Open DiscussionReplies: 3Last Post: 02-13-2008, 05:17 PM
By holdnon72 in forum Sea Doo Sport BoatsReplies: 1Last Post: 08-12-2007, 08:07 PM