Thread: Starter Bendix.
02-01-2015, 07:18 AM #1
Hi guys I'm just putting my order through so I can get my ski back together.
I noticed that when I removed the Pto cover the starter Bendix just wobbled about.
After a quick looki noticed it went stright back into place by just lining the gear up with the shaft and pushing it back in place.
Here re is a photo of it lined back up and below the photo is a link to a video of it just wobbling around out of place.
could you guys please tell me if this is normal. Thanks
Last edited by K447; 02-01-2015 at 09:27 AM. Reason: Bendix
02-01-2015, 10:05 AM #2
That's normal. It's supported by the pto cover when assembled.
02-01-2015, 02:56 PM #3
02-01-2015, 03:37 PM #4
Correct...And dont forget to put the spring washers back on the bendix shaft when assembling the housing back on too...
02-01-2015, 05:49 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By zx11rider in forum Yamaha ClassifiedsReplies: 1Last Post: 06-10-2010, 04:09 PM
By N8R in forum Yamaha ClassifiedsReplies: 5Last Post: 06-08-2010, 09:33 PM
By jitees in forum 4-Tec PerformanceReplies: 18Last Post: 03-20-2010, 06:19 PM
By Raider Kevin in forum Yamaha ClassifiedsReplies: 1Last Post: 07-25-2008, 08:08 PM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 15Last Post: 05-22-2006, 12:53 PM