Thread: Rxt x 260 impeller advice.
02-09-2015, 12:58 PM #1
Rxt x 260 impeller advice.
I tried doing a search but I still couldn't figure out what I needed to know. I'm about to order a few things for the 13' rxt and I need to know what impeller to order. The mods will be 4" kana flex, oil catch can, riva thru hull exhaust, r&d pump seal, new wear ring, and a vtech tune. Also I plan to fill the ride plate holes. The Ski will be used primarily on fresh water about 800' above sea level. Anyone with these mods wanna chime in? Also if you have this setup what mph are you seeing?
02-09-2015, 01:08 PM #2
a 15/19 or 15/20 would be the prop i would use. But frankly you may be able to get away using your stock prop, especially if you pitch it a tad. I was able to get 74 out of my stock prop without touching it. the elevation is going to hurt your power a tad.
02-09-2015, 03:51 PM #3
I have basically the same mods, except for no thru hull, I removed the FA, and I have a R&D flash. I run a 15/20. I have seen a best speed of 76.2.
02-09-2015, 03:54 PM #4
Video of the ski last year. At the time the ski only had 4 hrs on it.
02-10-2015, 08:11 PM #5
Thanks for the advice. I went with the 15/20. Troy, where did you order your seat cover for the tx?
02-10-2015, 09:32 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By swlamarshrunner in forum 4-Tec PerformanceReplies: 11Last Post: 02-04-2015, 03:29 PM
By jpt7779 in forum Sea Doo How To & FAQsReplies: 16Last Post: 08-07-2013, 03:54 PM
By fcs1965 in forum 4-Tec PerformanceReplies: 0Last Post: 08-25-2012, 11:08 PM
By jpt7779 in forum 4-Tec PerformanceReplies: 7Last Post: 09-12-2011, 04:51 PM
By sbquality in forum Yamaha Open DiscussionReplies: 9Last Post: 07-26-2010, 10:18 PM