Thread: 2010 RXTX Bailer System
02-12-2015, 12:31 PM #1
2010 RXTX Bailer System
After riding I always rinse the engine bay and prop up the tongue to drain it. But I think the bailer system doesn't allow it to drain completely. Can I remove the bailer system and just install direct drain plugs to drain it better?
02-12-2015, 01:31 PM #2
- Join Date
- Mar 2006
yes, you can install these: http://www.pwcdoctor.com/versiplug.html
To make them work as intended, you will have to remove your stocker setup and cut the inside flush with the inside haul-- like the '00 and older seadoos.
02-12-2015, 02:12 PM #3
Removing the stock bailer system is asking for trouble, even if you have electric bilge pumps. People underestimate how well the stock system works. The stock system, combined with electric pumps, has saved me on 2 occations.
02-12-2015, 02:42 PM #4
Agreed. Run the stock bailer and stuff in a Rule 800gph on a relay and have a nice day.
02-12-2015, 06:32 PM #5
I agree with Troy 100%.
Clean out your bailer tubes as they are probably gunked up and restricting the check valve.
I rinse my hull out every now and then also with Dawn soap and simply turn on my dual bilge pumps and it drains the water very quickly.
I fully admit getting to the damn bailer tubes under the battery and under the iBr system is a royal PITA!!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Glade Rider in forum 4-Tec PerformanceReplies: 14Last Post: 10-07-2010, 09:51 PM
By Scott in forum 4-Tec PerformanceReplies: 32Last Post: 07-22-2010, 09:48 AM
By Throttlemire in forum 4-Tec PerformanceReplies: 0Last Post: 03-01-2010, 08:53 PM
By SideFX in forum Sea Doo Open DiscussionReplies: 12Last Post: 04-29-2009, 09:12 PM
By ReDevilRXP in forum 4-Tec PerformanceReplies: 15Last Post: 09-29-2006, 09:35 PM