Thread: Bilge Pump installation
02-23-2015, 10:56 PM #1
Bilge Pump installation
going to install an 1100gph pump with a float switch. Will be connected to 3 way switch. Just looking for ideas of bilge outlet installation locations. Would like to be able to view any discharge so rear exit is out. Was thinking of mounting in footwell or just above so can see whilst riding.
Where have you mounted yours.
Last edited by Davrac; 02-23-2015 at 11:47 PM.
02-24-2015, 06:16 AM #2
Wire it straight to the float switch and leave out anything else. That way you only need to run one + wire from the battery and a second one to the motor for a ground Make it simple and self sufficient, adding a switch it just one more thing to break.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 14Last Post: 08-27-2014, 10:04 AM
By PWCManiac in forum Yamaha How To & FAQsReplies: 8Last Post: 08-02-2011, 07:35 PM
By kidafa in forum 2-Stroke PerformanceReplies: 25Last Post: 05-20-2009, 08:48 AM
By islandboy in forum 4-Tec PerformanceReplies: 7Last Post: 05-01-2008, 08:16 AM
By The Bandit in forum Sea Doo Open DiscussionReplies: 73Last Post: 08-07-2007, 06:41 PM